Home Enquiry Contact Us
  
   Company Profile
   Spaceframes
   P.E.B.
   Roofing
   Portable Cabins
   Pressure Vessels
   Tubular Structures
  

 

 

 

Specialization :- Space Frame
 

APPROVED BY TATAMOTORS (TELCO) FOR DESIGNING, MANUFACTURING AND ERECTING THREADED NODE TYPE SPACE-FRAMES FOR THEIR DEALERS AT VARIOUS LOCATIONS IN THE COUNTRY.

ADVANTAGES OF SPACE-FRAMES

  • Large spans can be achieved
  • Concentrated loads are evenly distributed on the entire structure
  • Pleasing decorative appearance
  • Fast installation at site due to pre-fabricated components
  • Very good acoustical properties

“The experience of the last (world) war proves that grids resist aerial attacks or explosions much better than any other structural system; local damage to the grid rarely, if ever,leads to a collapse of the entire structure”

Steel Space Structures – Z S Makowski

APPLICATIONS

  • Aircraft hangers
  • Factories
  • Cinema halls
  • Exhibition halls
  • Airports
  • Canopies

TYPES OF SPACE-FRAMES

  • SKELETON FRAMEWORKS
    Number of bars interconnected at the nodes
  • STRESSED SKIN SYSTEMS
    Using a composition of thin sheet material and ribs is a total structural system called STRESSED SKIN. It is the structural system used in aircraft, the space shuttle, unit body automobiles
  • SUSPENDED STRUCTURES
    Form of long-span structure that is subject to tension and uses suspension cables for support.

DOUBLE LAYER GRID

  • Of all the types of space-frames, the double layered grid structure is most popular because al its members are mainly under the action of axial forces,leading to the full utilization of all elements.
  • They are easily extendable

Double layered grids have a top frame , a bottom frame and inter-connecting diagonal members

Node Connector

Members (Pipe connector)
(Bolt, Collar, Bush end, MS pipe)

MANUFACTURING OF NODES

  • Billet cutting
  • Forging
  • Controlled cooling
  • Shot blasting
  • Master hole drilling &Tapping
  • Finish machining
  • Marking
  • Drilling & Tapping

MANUFACTURING OF COLLAR

  • Correct length cutting
  • Facing
  • Drilling
  • Slotting

MANUFACTURING OF BUSH ENDS

  • Correct length cutting
  • Facing
  • OD finishing
  • Drilling
  • Step boring
  • OD edge preparation
  • Taper turning

MANUFACTURING OF MEMBERS

  • Pipe correct length cutting
  • Edge preparation
    * Insertion of bolts
  • End bush set-up
  • Welding
  • Machining
    * Bolts have a 4mm Dia hole drilled for insertion of Dowell pins

A Typical welding joint of pipe connector

Our Designs…….

   
  
  
  

  
   << Back   

 

 

Best viewed in 1024 X 768. Developed by Softkey Solutions.